XBee & XBee-PRO 802.15.4 Adapters

Modelos

Características

Características

Features

• General
  • Frequency: 2.4 GHz (ISM)
  • Antenna options: Integrated whip antenna
• Performance
  • Indoor/Urban range:
    • XBee: Up to 100 ft (30 m)
    • XBee-PRO: 300 ft
  • Outdoor RF line-of-sight range:
    • XBee: Up to 300 ft (100 m)
    • XBee-PRO: Up to 1 mile
• Transmit power output:
  • XBee: 1 mW (+1 dBm)
  • XBee-PRO: 60 mW (+18 dBm)
• RF data rate: 250,000 bps o Receiver sensitivity:
  • XBee: -92 dBm (1% PER)
  • XBee-PRO: -100 dBm (1% PER)
• Networking and Security
• Network topologies: Point-to-Point, Point-to-Multipoint, Peer-to-Peer
• Number of channels:
  • XBee: 16 channels (Direct Sequence Spread Spectrum)
  • XBee-PRO: 12 channels (Direct Sequence Spread Spectrum)
• Filtration options: PAN ID, Channel, 264 (64-bit) addresses
• LEDs
  • Power: Glows green when external power is supplied (not active when battery powered to limit power drain)
  • Associate: Glows when unit is connected and associated on an RF network Controls
  • Device reset (internal push button) o Identification (internal push button): Relays identification to ConnectPort X gateway

Interfaces

• Serial
  • RS-232 (DB-9M)
  • RS-232PH (DB-9M); power harvesting version
  • RS-485 (6-position wire terminal block) - Switch selectable between RS-422 half duplex, RS-422 full duplex and RS-485
  • Sensor (RJ-45)
• USB
  • USB 2.0 Full Speed (with ESD protection); connects to host via captive 2-meter cable

Environmental

• XBee 232, 485, Sensor, USB, Analog I/O and Digital I/O
  • Operating temperature: -40° C to 70° C
  • Powering options
    • Battery: -18° C to 55° C
    • External power: 0° C to 40° C
    • External power (hardened): -35° C to 74° C
• XBee 232PH
  • Operating temperature: 0° C to 65° C

Power Requirements

• XBee 232, 485, Sensor, Analog I/O and Digital I/O
  • Externally powered: 9-30 VDC, locking connector
  • Battery powered: 3 internal N cell batteries
• XBee USB
  • Bus powered: +5V from USB bus
  • Power consumption during normal operation:
    • XBee: 70 mA
    • XBee-PRO: 70 mA (Rx) and 250 mA (Tx)
  • Power consumption during suspend mode:
    • XBee and XBee-PRO: 200 uA
• XBee 232PH
  • Internal battery provides power when unit is operating and recharges from the serial port when in sleep mode
  • Requires a sleep/wake duty cycle as part of its normal operation.
  • Requires a fully functional serial port conforming to the RS-232C standard for optimal operation.
  • Sleep/wake duty cycle requirements will vary based on the current output of serial port
  • Serial ports with more than 14VDC output (rare) are not supported and may cause malfunction
  • Serial ports that provide hard power of 5 to 14VDC on one or more pins will allow the device to operate continually without a sleep/wake cycle

Dimensions

• XBee 232, 485, Sensor, Analog I/O and Digital I/O
  • Width: 1.68 in (4.26 cm)
  • Height: 0.99 in (2.53 cm)
  • Length: 3.87 in (9.84 cm)
  • Weight: 2.29 oz (6.50 g)
• XBee USB and 232PH
  • Width: 1.80 in (4.57 cm)
  • Height: 0.83 in (2.10 cm)
  • Length: 2.87 in (7.29 cm)
  • Weight: 1.60 oz (45.36 g)

Aplicações

Documentação

Literatura

• Users Guide: XBee / XBee-PRO Drop-in Networking Adapters and Accessories
•  XStick 802.15.4 USB Adapter